Miele G7881 fault codes - errors - códigos de erro

F 0E
After a delay of 5 seconds a flow meter in the water intake does not
provide a minimum of 5 pulses within the next 2 seconds.
If no pulses are registered during the first water intake in a program with
legally fixed cleaning parameters, then the program will only advance to
the next step if the heating level switch switches to register sufficient
water level. If it does not switch, the fault code F0E is displayed.
In the test program the delay time has been extended from 5 seconds to
23 seconds as in this case it may be necessary for the appliance water
paths to be filled.


F 1E
The water intake is switched off within 5 minutes even though the number
of pulses for the set water intake quantity has not been registered
In programs (first water intake only) with legally fixed cleaning parameters
a minimum water quantity is not monitored. To advance from the water
intake step the heating level switch must have switched to register
sufficient water level. If it does not switch, the fault code F1E is displayed
if the pulses from the flow meter are registered or the fault code
F0E is displayed when no pulses are detected.


F 2E
During water intake a flow meter provides sufficient pulses but the
quantity of water required is not taken in during the given time of 5
minutes.


F 3E
2 seconds after the water intake step the heating level switch is monitored
for 2 seconds. If it has not switched, the step is not advanced and the
fault code F3E is displayed. After a voltage interruption in the appropriate
step, the heating level switch is not checked again. As it is possible to set
a desired water quantity of 5.5 liters or 5 liters via programmable function
E 01 in wash blocks VR1, VR2, SP2, and SP3, then with a desired water
quantity less than or equal to 6 liters this fault monitoring is not active.
If insufficient salt is registered in the salt container, the fault indicator LED
Recharge softener lights up. The program is not interrupted.



F 23
If reactivation is carried out for a second time after a lack of salt has been
registered, the fault indicator LED flashes and the fault code
F23 is displayed. This fault is also recorded via the printer interface.


F 4E
Flow meter provides pulses during a non-water intake step
Appropriate water intake valve is open


F A
The heating level switch has switched after a drainage step
Residual water still in cabinet


F SA
The insufficient salt warning indicator has been ignored for too long
Even though the insufficient salt warning LED has been lit, reactivation salt has not been added


F 08
The speed sensor
B3/9 does not provide any pulses
though they are required (e.g. with gentle start mechanism)
- Circulation pump blocked